Certance LTO-1 Uživatelský manuál stáhnout pdf

Firmware Up

rade

User Guide

1. INTRODUCTION

Firmware is the binary code stored in the tape drive’s permanent memory that controls its basic

operation. Firmware revisions may be released by the manufacturer to address specific issues

discovered after manufacturing. The Certance Tape Drive Firmware Upgrade utility (DFU) can be

used to upgrade firmware on supported Certance tape drives.

IMPORTANT: If your tape drive was purchased as part of a computer system, be sure to check

with the system manufacturer before upgrading firmware. You may have a special version of

firmware, and replacing it with a standard version may cause incompatibilities.

Supported operating systems

• Windows 2000/XP/2003 (should also work on Windows NT 4.0)

• Red Hat Linux 3.0 (should also work on 7, 8 and 9 and Enterprise 2.1)

• NetWare 5.1 and 6.5

• Solaris 8 and 9

Supported Devices:

Certance DAT24 (DDS-3) Tape Drive

Certance DAT40 (DDS-4) Tape Drive

Certance DAT 72 Tape Drive

Certance DAT240 Autoloader (DDS-4)

Certance DAT432 Autoloader (DAT 72)

Certance Travan 40 Tape Drive

Certance LTO-1 Ultrium Tape Drive

Certance LTO-2 Ultrium Tape Drive

1 2 3

Firmware Upgrade User Guide 1. INTRODUCTION Firmware is the binary code stored in the tape drive’s permanent memory that controls its basic operati

Certance LTO-2 Half-Height Ultrium Tape Drive Certance LTO-3 Ultrium Tape Drive NOTE: Firmware upgrade to the robotics or controller is not supported

APPENDIX A – INSTALLATION NOTES Windows: 1. When using Firmware Upgrade for the tape drive in an autoloader/changer, the Removable Storage Manage

Další dokumenty pro Páskové jednotky Certance LTO-1

Žádné komentáře